Skip to main content

Speaking of 1.25m, check out what just showed up yesterday. :O

I've never seen TNC connectors in person before. :P

#AmateurRadio #HamRadio

50W 1.25m transverter from Q5 Signal and Down East Microwave. It accepts a 10m signal and upconverts it to 1.25m.
Rear of the transverter, showing the BNC and TNC ports among others.
#hamradio #amateurradio

Patrick W1PAC reshared this.

in reply to Neil E. Hodges

Neil E. Hodges
Neil E. Hodges
•

I wanted this because my FT-991A does 2m and 70cm, but not 1.25m.

The same merchant also has models for outputting 2m, 70cm, 33cm, and 23cm. 👀

Patrick W1PAC reshared this.

in reply to Neil E. Hodges

Man aging with pi
Man aging with pi
• •

that's not a TNC; that's an N connector.

TNC (threaded nut connector) is about the same dimensions as
BNC (bayonet nut connector). N connectors are the same thread size as UHF (universal high frequency), but the interior are the same as BNC/TNC.

So, it is possible to remove the nut from a BNC and plug it into an N.

in reply to Man aging with pi

Neil E. Hodges
Neil E. Hodges
•
You're not the only one to notice that. Had to order some new connectors. :(
in reply to Neil E. Hodges

Aladár Mézga
Aladár Mézga
• •
Are you sure that those are TNC, not BNC?
in reply to Aladár Mézga

Neil E. Hodges
Neil E. Hodges
•
The right ones are BNC and the left one is actually N (pointed out by a few folks on different services).
in reply to Neil E. Hodges

Gary @N8DMT
Gary @N8DMT
• •
Thinking the Ant/TX port is a N-connector as TNC are similar diameter as BNC, but threaded instead of twist-lock. Looks super-nice! Have fun on on 222!
⇧